I just started a 49.5 hour print. I don't have enough filament to finish it, but I've ordered another spool with expected delivery today.
It's also an MMU print with 1678 filament changes.
Wish me luck!
⇧
I just started a 49.5 hour print. I don't have enough filament to finish it, but I've ordered another spool with expected delivery today.
It's also an MMU print with 1678 filament changes.
Wish me luck!
Kernel Bob
in reply to Kernel Bob • • •The long print is 10% done with no issues so far. My assistant has acquired and inspected the new filament, so that hurdle's cleared.
#3DPrinting
Kernel Bob
in reply to Kernel Bob • • •24 hours in, 40% done. It' starting to look like two hearts.
The printer has required three interventions at 17%, 39%, and 40%. I was sleeping, so completion time is pushed out about four hours.
#3DPrinting
Kernel Bob
in reply to Kernel Bob • • •48 hours in, 82% done. It definitely looks like two hearts.
The printer has required six interventions so far. The one at about Z = 55mm had the clay red filament wrapped around the spool, so there's some missing plastic at that height.
Estimated print time is now up to 52 hours. I wasn't always there when the printer needed help.
#3DPrinting
Kernel Bob
in reply to Kernel Bob • • •I adjusted the height of the FINDA (MMU filament sensor) at 50% complete, and it hasn't needed intervention since. (Knock on woodfill PLA.)
#3DPrinting #Prusa #MMU3
Kernel Bob
in reply to Kernel Bob • • •It finished! And one of these hearts will make a very nice gift.
56 hours all told.
No further interventions needed today.
My MMU has done a lifetime total of 10,508 filament changes now. 1,678 of them in this print.
#3DPrinting #Prusa #MMU3